Testing, quality and handling
Amino Acid Analysis of Peptides: What Composition Can and Cannot Prove
NB
· 10 min read
A summary of published research, with citations. It states no amount, schedule or route, and makes no claim about what this compound does in a person. Supplied for laboratory research use only.
On this page · 7 sections
Amino acid analysis breaks a peptide into its constituent amino acids with strong acid, tags them with a reagent that makes them detectable, and separates and quantifies them by chromatography. Because the intended sequence predicts how many of each residue should appear, the result establishes two things: the composition of the material and, by comparison with the weighed mass, how much of that mass is peptide. It establishes nothing about the order of the residues, and several residues are partly or wholly destroyed by the hydrolysis step itself.

What question does amino acid analysis answer?
Three different questions get asked of a synthetic peptide, and three different methods answer them.
Chromatographic purity asks what share of the detected material is the main component. Identity asks whether that component is the intended molecule. Net peptide content asks what share of the weighed powder is peptide at all, rather than counter-ion, water or salt. Amino acid analysis is the classical reference answer to the third question, and a partial answer to the second.
Fountoulakis and Lahm describe it as a two-step technique — hydrolysis of the substrate, then chromatographic separation and detection of the residues — and as indispensable for protein quantification (PMID 9917165). That word, quantification, is the point. A mass spectrometer tells you what a molecule is far faster than this does. What it does not tell you is how many milligrams of peptide sat on the balance, because ionisation response varies between compounds and is not a measure of amount.
The mechanics are worth stating plainly, because every limitation below follows from one of the steps.
| Step | What happens | What it costs |
|---|---|---|
| Hydrolysis | Strong acid, heat, hours to days, cleaves every peptide bond | Destroys or alters several residues; can racemise others |
| Derivatisation | A reagent tags each free amino acid so a detector can see it | Reagent chemistry sets sensitivity and which residues resolve |
| Separation | Ion-exchange or reverse-phase chromatography resolves the tagged residues | Co-eluting pairs are the usual failure mode |
| Quantification | Peak areas against standards of known concentration | The standard, not the sample, sets the accuracy ceiling |
Which amino acids are lost during hydrolysis?
This is the part most summaries skip, and it is the reason a composition table never reports every residue with equal confidence.
Conventional hydrolysis in hydrochloric acid at elevated temperature destroys tryptophan almost completely. Asparagine and glutamine lose their side-chain amide groups and are measured as aspartate and glutamate, so a composition report conventionally gives combined values — the pair Asx for asparagine plus aspartate, Glx for glutamine plus glutamate. Cysteine and methionine are vulnerable to oxidation. Serine and threonine degrade slowly throughout the hydrolysis. Bonds involving valine, isoleucine and leucine, by contrast, are stubborn and may still be incompletely cleaved when the labile residues have already begun to disappear.
Those two facts pull in opposite directions, which is the central problem of the method: the hydrolysis must run long enough to finish cleaving the resistant bonds and short enough to spare the fragile residues. Darragh and colleagues addressed this directly by hydrolysing egg-white lysozyme over eighteen different intervals ranging from two to 141 hours and fitting the simultaneous release and decay of each amino acid, recovering a mean of 100% against the known composition with a range of 94 to 110% (PMID 8660495). Their later review makes the practical point that correction factors derived this way have to be determined for individual proteins rather than applied uniformly (PMID 16001867).
Several workarounds exist for the specific casualties:
- Tryptophan survives alkaline hydrolysis, which destroys other residues; Hugli and Moore set out the ion-exchange determination of tryptophan content from alkaline hydrolysates (PMID 4554361). Simpson and colleagues achieved tryptophan recovery close to theoretical using methanesulfonic acid with an indole additive, in a procedure designed to give the complete composition from a single hydrolysate (PMID 178649).
- Cysteine is usually converted deliberately to a stable derivative before hydrolysis — oxidation to cysteic acid with performic acid is the classical route — so that it can be quantified as one defined species rather than lost across several.
- Everything else improves with better hydrolysis chemistry. Weiss and colleagues compared acid-hydrolysis methods and found conventional thermal hydrolysis in methanesulfonic acid the most accurate, closely followed by hydrochloric acid, with microwave-accelerated hydrolysis faster but responsible for a higher degree of racemisation of the residues (PMID 9528102).
Contaminants matter too, and the trap is a good one. Manneberg and colleagues found that sodium azide, widely used as a bacteriostatic agent during protein processing, generated cysteic acid, methionine sulfoxide and methionine sulfone during hydrolysis — oxidation products that were absent when the azide was removed first (PMID 7710058). The analysis would have reported an oxidised peptide that was not oxidised before the analyst touched it.
How are the amino acids detected?
Free amino acids absorb poorly and fluoresce not at all, so almost every modern method tags them first. Two reagents built the field. Heinrikson and Meredith described precolumn derivatisation with phenylisothiocyanate, which converts every amino acid including proline quantitatively to a phenylthiocarbamyl derivative detectable at 254 nm after reverse-phase separation (PMID 6711815). Cohen and Michaud synthesised a fluorescent reagent, 6-aminoquinolyl-N-hydroxysuccinimidyl carbamate, which reacts in one step, tolerates buffer salts and detergents, and gave detection limits in the tens to hundreds of femtomoles with complete resolution in under 35 minutes (PMID 8317704).
The reference-laboratory version has moved on again. Melanson and colleagues at the National Research Council of Canada used amino acid analysis by isotope-dilution tandem mass spectrometry as one of three orthogonal methods to assign a purity value to a candidate angiotensin II certified reference material (PMID 30143839). Isotope dilution removes most of the recovery problem: a labelled version of each amino acid is added before hydrolysis, so anything that destroys the analyte destroys the standard alongside it.
How does composition give net peptide content?
Arithmetically, and that is the method's main practical use.
Take a known mass of the powder. Hydrolyse it. Quantify the stable residues — typically alanine, glycine, leucine, phenylalanine, valine and the other robust ones, chosen for that sequence. Because the sequence states how many of each the molecule contains, the moles of a stable residue divide straight into moles of peptide. Multiply by molecular weight and you have the mass of peptide that was in the weighed sample. The ratio of the two is the net peptide content, and the difference between them is counter-ion, water and everything else.
That difference is not small. In the angiotensin II work above, the trifluoroacetate counter-ion alone accounted for nearly 25% of the mass, and the final assigned value was 691 ± 9 mg of peptide per gram of material (PMID 30143839). Why a synthetic peptide arrives as a trifluoroacetate salt in the first place is covered in TFA and acetate peptide salts, and the consequences of ignoring the gap are set out in net content versus purity.
Two cautions attach to the arithmetic. Amino acid analysis counts residues, not molecules, so a related peptide impurity contributes its amino acids to the total as though it were the target — which is why reference work corrects for related impurities explicitly rather than ignoring them. And the result is only as good as the weighing: a hygroscopic lyophilised solid gains mass from humid air while it sits on the balance.
What amino acid analysis cannot establish
The order of the residues. This is the hard limit. Hydrolysis is total; the product is a pool of free amino acids with no memory of their arrangement. Two peptides that are sequence permutations of each other give identical compositions. Establishing order requires fragmenting the intact molecule and reading the pieces, which is the subject of peptide sequencing by tandem mass spectrometry.
Chirality, by default. A D-residue and its L-counterpart are the same amino acid to an ordinary analysis. Separating them needs a chiral derivatising reagent or a chiral stationary phase, and the hydrolysis itself racemises some fraction of what it releases — which is why the chiral methods in D-amino acids in peptides hydrolyse in deuterated acid, to label and discount whatever racemised in the tube.
Modifications that survive as ordinary residues. Deamidation converts asparagine to aspartate, and conventional hydrolysis does the same thing deliberately. A deamidated peptide and an intact one can give the same Asx figure.
Anything about structure. Disulfide connectivity, folding and aggregation state all vanish in the first step. Those questions are the subject of disulfide bonds in peptides.
A composition that matches the theoretical one is therefore consistent with the intended peptide without proving it, and that is the honest way to state the result.
Does a research-chemical certificate ever include it?
Rarely. The common certificate in this market reports chromatographic purity by HPLC and sometimes an intact mass, and a purity figure says nothing about how much peptide the vial holds — the distinction drawn in what a certificate of analysis establishes and in HPLC and LC-MS testing. Amino acid analysis is a separate commissioned test with its own sample preparation, and it is the test to ask about when comparing lots by weight actually matters to an experiment. Nothing here is medical, dosing, or therapeutic guidance.
Frequently asked questions
Can amino acid analysis confirm a peptide's identity? Only partially. A composition matching the theoretical one rules out many wrong molecules, and a composition that does not match is strong evidence something is wrong. But permutations of the same residues are indistinguishable, and so are several modifications that hydrolysis converts into ordinary amino acids. Identity needs mass spectrometry; sequence needs fragmentation.
Why are asparagine and glutamine reported combined with aspartate and glutamate? Because acid hydrolysis removes their side-chain amide groups and converts them. By the time the analysis runs, asparagine has become aspartate and glutamine has become glutamate, so the measurement cannot distinguish an original aspartate from a converted asparagine. Reports write the combined values as Asx and Glx.
How much material does an analysis need? Modern derivatisation chemistry works at low levels: the aminoquinolyl reagent gave useful compositional data from protein hydrolysates containing as little as tens of nanograms, with detection limits in the femtomole range for individual residues. The practical limit is usually accurate weighing of the starting material rather than detector sensitivity.
Is amino acid analysis better than quantitative NMR for net content? Neither is strictly better, which is why reference laboratories run both. Hydrolysis introduces bias that quantitative NMR avoids by measuring the intact peptide, while NMR requires more material and a certified internal standard. The angiotensin II reference work combined the two with a mass-balance approach and found the three methods in good agreement.
Does hydrolysis create D-amino acids? Yes, some. Racemisation during hydrolysis is a known artefact and is worse with microwave acceleration than with conventional heating. Any chiral analysis that does not account for it will overstate the D-content of the original peptide, which is why the standard approach hydrolyses in deuterated acid so that residues racemised in the tube carry a mass label.
Selected Research References
- Fountoulakis M, Lahm HW. Hydrolysis and amino acid composition of proteins. Journal of Chromatography A. 1998;826(2):109-134. pubmed.ncbi.nlm.nih.gov/9917165
- Weiss M, Manneberg M, Juranville JF, et al. Effect of the hydrolysis method on the determination of the amino acid composition of proteins. Journal of Chromatography A. 1998;795(2):263-275. pubmed.ncbi.nlm.nih.gov/9528102
- Darragh AJ, Garrick DJ, Moughan PJ, et al. Correction for amino acid loss during acid hydrolysis of a purified protein. Analytical Biochemistry. 1996;236(2):199-207. pubmed.ncbi.nlm.nih.gov/8660495
- Darragh AJ, Moughan PJ. The effect of hydrolysis time on amino acid analysis. Journal of AOAC International. 2005;88(3):888-893. pubmed.ncbi.nlm.nih.gov/16001867
- Simpson RJ, Neuberger MR, Liu TY. Complete amino acid analysis of proteins from a single hydrolysate. Journal of Biological Chemistry. 1976;251(7):1936-1940. pubmed.ncbi.nlm.nih.gov/178649
- Hugli TE, Moore S. Determination of the tryptophan content of proteins by ion exchange chromatography of alkaline hydrolysates. Journal of Biological Chemistry. 1972;247(9):2828-2834. pubmed.ncbi.nlm.nih.gov/4554361
- Heinrikson RL, Meredith SC. Amino acid analysis by reverse-phase high-performance liquid chromatography: precolumn derivatization with phenylisothiocyanate. Analytical Biochemistry. 1984;136(1):65-74. pubmed.ncbi.nlm.nih.gov/6711815
- Cohen SA, Michaud DP. Synthesis of a fluorescent derivatizing reagent, 6-aminoquinolyl-N-hydroxysuccinimidyl carbamate, and its application for the analysis of hydrolysate amino acids via high-performance liquid chromatography. Analytical Biochemistry. 1993;211(2):279-287. pubmed.ncbi.nlm.nih.gov/8317704
- Manneberg M, Lahm HW, Fountoulakis M. Oxidation of cysteine and methionine residues during acid hydrolysis of proteins in the presence of sodium azide. Analytical Biochemistry. 1995;224(1):122-127. pubmed.ncbi.nlm.nih.gov/7710058
- Melanson JE, Thibeault MP, Stocks BB, et al. Purity assignment for peptide certified reference materials by combining qNMR and LC-MS/MS amino acid analysis results: application to angiotensin II. Analytical and Bioanalytical Chemistry. 2018;410(26):6719-6731. pubmed.ncbi.nlm.nih.gov/30143839
All products sold by NovaEvum are for research and laboratory use only. They are not intended for human or animal consumption, diagnosis, treatment, cure, or prevention of any disease.
